![]() ![]() If you need to measure the distance between two shapes you can click and drag between and two anchor points and get the above information but pertaining to the two nodes. Value is empty otherwise.īelow you can see further examples of the state of the measurement tool dialog, based on the type of segment being measured. As nouns the difference between ruler and king is that ruler is a (usually rigid), flat, rectangular measuring or drawing device with graduations in units of measurement a rule a straightedge with markings a measure while king is a male monarch a man who heads a monarchy if it's an absolute monarchy, then he is the supreme ruler of his nation or king can be. Arc Center: For curves that are perfect circular arcs and not complex bezier curves, this is the center point of that arc.Arc Radius: For curves that are perfect circular arcs and not complex bezier curves, this is the radius of that arc.In the case of regular line segments this is the angle of the line itself. Angle: Angle of the line between the start and end points.Difference: End Point values minus the Start Point Values.End Point: X,Y coordinate of the end node of the currently highlighted line/curve segment.Start Point: X,Y coordinate of the start node of the currently highlighted line/curve segment.Segment Length: Length of the line/curve segment currently highlighted in purple.Defined as all line/curve segments beginning and ending on nodes shared with another line/curve segment. ![]()
0 Comments
Leave a Reply. |